Specification:
Condition: 100% Brand New
Item Type: Arrow Rest
Material: aluminium alloy
Color: blue
Installation:
Install the archery arrow rest directly on the bow handle with the 5/16"-24 screw of the sleeve gasket. The arrow rest must be kept level. Then push the nail against the handle.
Adjustment:
- Forward and backward adjustment: loosen the set wire, loosen the 5/16 "-24 arrow table fixing screw, move the arrow table mounting seat to the appropriate position, tighten the fixing screw, and then tighten the nail wire.
- Vertical adjustment: loosen the vertical adjustment set screw, twist the vertical adjustment knob with hand or wrench, and tighten the vertical adjustment set screw after adjusting to the appropriate position.
- Left and right adjustment: loosen the left and right adjustment set screw, twist the left and right adjustment button with hand or wrench, and tighten the left and right adjustment set screw after adjusting to the appropriate position.
- Angle adjustment: loosen the angle adjustment nail wire at the bottom of the archway and loosen the fixing screw of the steel plate base. After adjusting the angle of the steel plate base properly, first tighten the Angle adjustment nail wire and then tighten the fixing screw of the steel plate base.
Replacement of steel sheet:
With 3 kinds of replaceable steel, suitable for different weight, different diameter of shaft
Loosen the fixing screw of the pressing plate, remove the steel plate and replace the steel plate. Then place the steel plate onto the steel plate and screw it down. When the steel plate is installed, the locating hole in the center of the steel plate should fit perfectly with the raised on the steel plate base.
How to read cursor scales:
A vernier scale is an additional scale that allows for more accurate reading of distance measurements rather than direct reading of measurement scales. It is a sliding secondary scale used to indicate the position of measurement when it is between two marks on the main ruler. When measuring the length, the 0 on the sub-scale is the actual point of measurement, but it may be between the data scale points. For example, if the sub-rod 0 is adjusted to the right, 5 on the right of the main rod 0 and 4 on the right of the sub-rod 0 are aligned with the line of the main rod, then 5.4 scales are adjusted to the right.
On the other hand, if the minor ruler 0 is outside 5 to the left of the major ruler 0, and the 4 to the left of the minor ruler 0 is aligned with the major ruler, then 5.4 scales are adjusted to the left.
Features:
1Horizontal and vertical adjustment, accurate scale. Steel sheet adjustable angle. 2Repeatable settings: both vertical and horizontal millimeter scales have a scale (like a caliper). Multiple adjustment accuracy can be reduced to 0.16mm. 3By rotating the steel plate mounting seat, the steel plate can be adjusted to different angles. 0to 45 . 4A raised mounting seat ensures the consistency of the position of the steel sheet after mounting. Reduce the precision reduction caused by the replacement of steel sheet. 5Stainless steel 5/16"-24 mounting screws, washers made of special plastic, allow for better fixation of the bolts and avoid screw damage to the arrow rest main body. 6The size and thickness of the steel sheet can be used to accommodate a variety of arrow diameters and weights.
Package List:
3 x Steel Plate
1 x Arrow Rest
4 x Hex Wrench
1 x Screw
1 x Manual