Specification:
Item Type: Immobiliser Emulator
Material: ABS
After decoding of for Renault injection computer using for RENAULT RESET TOOL or by entering security code, in most cases you can start engine, but some of injection computers can not operate without immobilizer code stored in their memory.
Diesel EDC15C3, DCU3R and MSA15, petrol SIRIUS32 (except those for 1.4Lengine) and FENIX5 for 2.0L 16V engine require working unlocked (with good key) immobilizer unit or for Renault immobilizer emulator.
Fitment:
Fit for Renault models, fitted with single-data-wire coded immobilizers. I.E.from 1994 approx. until the introduction of CAN (2001 to 2003, dependingon exact model).
Immo pin code is not required
Decode the ecu using the for renualt ecu decoder.
Only 3 wires to connect: Ignition, Ground and Data.
Small module size
Module is designed to be left permanently connected to the car.
Non-volatile memory means no data loss, even after flat batteries or for jump startS.
Module can be used again if need be.
Petrol ECU's
For SIEMENS FENIX3B
For SIEMENS FENIX5
For SIEMENS SIRIUS32
For SAGEM SAFIR (55pin)
For SAGEM SAFIR2 (35pin)
For BOS CH. MOTRONIC MP7.0
For MAGNETI MARELLI IAW 06R
For MAGNETI MARELLI IAW 8R.30
For Diesel ECU's
For BOS CH. MSA15.5 (DTI)
For BOS CH. EDC15C3 (DCI)
For LUCAS DCU3R (1.9D)
Coded fuel cut-off valve (1.9D DDS)
Fitting Process:
- Ensure that the ecu has been decoded. This can be done with the for Renault ecu decoder
- Connect the module to the car's wiring harness: Red wire to ignition feed, black wire to earth, and yellow wire to the data wire
- Cut the wire to the immobilizer, so that the module is connected directly to the engine ECU, and the immobilizer is out of the circuit.
- Turn ignition back on, the car should now start.
Features:
1Emulator module is capable of emulating an immobilizer data stream to the ecu. It can do this every time ignition is turned on meaning that you have a car which simply starts, even just using a steel (non electronic) key. 2Specially fit for Renault models fitted with singledatawire coded immobilizers, I.E. from 1994 approx. until the introduction of CAN (2001 to 2003, dependingon exact model). 3The engine ECU won't run the engine until it receives a coded message (a 'unique' number) from the immobilizer. The 'unique' part means that every immobilizer is different, and so swapping immobilizers won't help get a car running. 4Use together with for RENAULT ECU DECODER for a complete kit, the immobilizer may be a stand alone unit, or it maybe built in to a larger control unit. 5Once the ecu has been decoded, the emulator should be done direct to the ecu or along the immobilizer wiring room. After connecting the emulator cut the immobilizer line from the immobilizer unit.
Package List:
1 x Immobiliser Emulator Module