Specification:
Features:
The protection board is for 10 series cell Li-ion batteries, it can be used for 3.7V ternary batteries, manganese acid batteries and cobalt acid batteries.
It has balance function which would ensure each battery cell being fully charged at same time.
Support overcharge protection, over-discharge protection and short circuit protection.
It is suitable for electric car, electric power assistant car, skateboard car, inverter, etc
Suitable for several kinds of batteries, safe, reliable and easy to use.
Specifications:
Applicable voltage: 36V
Applicable power: <1000w
Maximum working current: 30A
Continuous maximum current: 20A
Overdischarge protection voltage: 2.6v
Overcharge protection voltage: 4.25v
Charging current: Maximum 10A
Balance voltage: 4.2v
Weight: 46g
BMS Protection Board Wiring Steps
1. Firstly connect the batteries in series
2. Ensure that the voltage of each string is the same (the difference between the highest voltage and the lowest voltage is preferably within 0.1V), and the voltage range is between 3.2-4.0V.
3. Firstly connect the distributed cable, connect according to the diagram, and insert the cable port into the board port after checking it is correct (first connect the battery, then insert the board, the step cannot be reversed).
4. Check whether the total positive voltage of the C-port and P-port to the battery is equal to the total voltage of the battery. If they are equal, the board is working normally.
5. Solder the battery negative B- to the port marked B- on the board.
6. Both the battery output negative electrode and the charging negative electrode of the same port board are connected to the port marked C- on the board (the P- port is just floating).
7. Separate port (different port) board, the battery output negative pole is welded P-, and the charging negative pole is welded into the port marked C- on the board.
Package included:
1 x Protection Board
1 x Cable
Note:
Please note that the new type and old type of this product will be sent randomly, and make sure you will not mind before ordering.
Features:
1The protection board is for 10 series cell Liion batteries, it can be used for 3.7V ternary batteries, manganese acid batteries and cobalt acid batteries. 2It has balance function which would ensure each battery cell being fully charged at same time. 3Support overcharge protection, overdischarge protection and short circuit protection. 4It is suitable for electric car, electric power assistant car, skateboard car, inverter, etc 5Suitable for several kinds of batteries, safe, reliable and easy to use.
Package List: