Specification:
Condition: Brand New
Item Type: Pneumatic Spray Gun
Material: Stainless + Carbonado
Color: As the Picture Shown
Caliber: Approx. 2.0mm/0.08in
Capacity: 1000ml
Working Pressure: 0.25-0.4 (Mpa)
Diameter of Spray Hole: Approx. 2mm/0.08in
Air Connector Size: 0.43in (1.1cm)
Paint Spraying Volume: 435 (ml/min)
Effective Spray Distance: Approx. 20cm/7.9in
Air Consumption: 5-10 (l/min)
Scope of Application: Latex Paint, Primer and Top Coat Spraying
Air connection to SP20 quick connector or 8mm OD tube
Instructions
1. Pour the paint with a good proportion into the paint pot and connect it with the feed joint.
2. Connect the compressed air to the air inlet connector.
3. Pull the trigger and adjust the proper working air pressure (3.5-4.5bar).
4. Adjust the amount of paint and spray width (adjust as needed).
5. Parallel and vertical spray on the clean surface (spray distance is about 20cm).
The difference between upper and lower pots:
- The lower pot S is suitable for spraying horizontally or less than 45 degrees up and down.
- The upper pot G can be rotated, suitable for 360-degree spraying.
-
The lower pot capacity is large, and the upper pot capacity is small according to the usage scenario.
Maintenance and maintenance of spray gun:
-
After each spraying, clean up the excess paint in the pot in time, then wash the inside and outside of the pot with diluent, and clean the outside of the suction tube (only the lower pot).
-
Pour the diluent into the clean pot and connect Connect the feed connector of the upper gun body to the air source.
-
Pull the trigger to spray the diluent until it is confirmed that there is no paint residue in the paint channel, and then take back the excess diluent in the pot.
-
Unscrew the flow cap, moisten the brush with diluent, and scrub the inner and outer surfaces of the flow cap, as well as the small holes (if there is dirt in the hole, you can use a toothpick to dredge, but it is forbidden to use metal objects or it will damage the atomization effect).
-
Dip the diluent with a brush, brush the surface of the nozzle and the small holes, if there is dirt in the hole, use a toothpick to dredge (normal cleaning does not need to remove the nozzle).
-
Wipe the dry cap and nozzle with a clean cloth and retwist the cap.
-
Finally, roughly wipe the overall surface of the gun body with a cloth.
-
Do not immerse the entire gun body in thediluent for cleaning, otherwise it will cause dryness of each active part and affect the normal use!
Features:
1Advanced equipment manufacturing, high degree of atomization, low energy consumption, high efficiency and convenient use. 2The spray gun is made of black diamond material, which is sturdy and durable. 3The nozzle is made of wearresistant, corrosionresistant, highstrength stainless steel, and the nozzle can be removed for cleaning and maintenance. 4The most suitable spraying distance is about 200mm, which can better meet your needs. 5Suitable for a variety of different applications, such as automotive, industrial, marine and wood work.
Package List:
1 x Pneumatic Spray Gun
1 x Sprinkling Can
1 x Wrench
1 x Cleaning Brush
