Specification:
Item Type: Electric Motor
Material: Carbon steel
Purpose: Industrial motor control, transmission and transmission occasion
Step Angle: 1.8
Current: 1.5A
Holding Torsion: 0.28N.m
Resistance: 2.4
Inductance: 2.8mH/phase
Length: Approx. 34mm / 1.3in
Number of Outlets: 4
Shaft Type: Milling single flat table
Step Angle Accuracy: 5% (full step)
Resistance Accuracy: 10% (20)
Inductance Accuracy: 20% (1KHZ)
Temperature rise 80 maximum (rated current, 2-phase energization)
Ambient Temperature: -20~+50
Insulation Resistance: 100MMin, 500VDC
Radial Clearance: 0.02mm maximum (450g load)
Axial Clearance: 0.08mm maximum (450g load)
Maximum Radial Load: 28N (20mm from flange surface)
Maximum Axial Load: 10N
Features:
1Imported highquality motor steel sheets, bearings made of German technology, low selfinductance, good responsiveness. 2The product can be directly connected to the load and run at low speed in a state of close to a locked rotor without gear reduction. 3The product can produce a high torsiontoinertia ratio on the loaded shaft, and can eliminate system errors caused by the use of reduction gears. 4The inner rotor adopts German technology, and the surface is coated with imported rotor glue to prevent burrs on the surface after carbon steel oxidation and grinding, resulting in increased motor noise. 5The front and rear covers are perfectly connected, the body is black electrophoresis, highend atmosphere, and the body size is standard.
Package List:
1 x Electric Motor