Specification:
Item Type: NEMA14 Stepper Motor
Material: Carbon steel
Purpose: Industrial motor control, transmission transmission scene
Step Angle: 1.8
Current: 1.8A
Keep Torsion: 0.22N.m
Resistance: 2.7
Inductance: 4.3mH/phase
Length: Approx. 42mm / 1.7in
Number of Outlets: 4
Shaft Type: Milling single flat table
Step Angle Accuracy: 5% (full step)
Resistance Accuracy: 10% (20)
Inductance Accuracy: 20% (1KHZ)
Temperature Rise: 80 maximum (rated current, 2-phase energization)
Ambient Temperature: -20~+50
Insulation Resistance: 100MMin, 500VDC
Radial Clearance: 0.02mm maximum (450g load)
Axial Clearance: 0.08mm maximum (450g load)
Maximum Radial Load: 28N (20mm from flange surface)
Maximum Axial Load: 10N
Features:
1Highquality motor steel sheet, low selfinductance and good responsiveness, can be directly connected to the load and run at low speed without gear reduction. 2Can produce a high torsion to inertia ratio on the loaded shaft, and can eliminate the system error caused by the use of reduction gears. 3The inner rotor adopts German technology and the surface is coated with imported rotor glue to prevent burrs on the surface after the carbon steel is oxidized and ground, causing the noise of the motor to increase. 4The front and rear covers are perfectly connected, the fuselage is black electrophoresis, highend atmosphere and standard size. 5With accurate control, the number of pulses determines the position of the motor, quick start and stop, frequent CW and CCW.
Package List:
1 x NEMA14 Stepper Motor
