Specification:
Item Type: Vector Network Analyzer
Material: Aluminum Alloy
Impedance: 50
Test Port Connector: SMA Female
Testing Ports: 2
Frequency Range: 100kHz to 6GHz
Frequency Accuracy: <2ppm
Measurement Point: 2-4501
Speed: <500ms (IFBW=50kHz)
Measurement Bandwidth: 10Hz-50kHz
Dynamic Range (IFBW 10Hz): >95dB-3GHz; >50dB-6GHz (Note 1)
Measurement Parameters: S11, S21, S12, S22
Reflection Directionality: >40dB (after calibration) (Note 2)
Output Power: -40-0dBm (Note 3)
Power Supply: DC 5V, 1.5A (USB powered, or 3.5mm connector)
Power Consumption: About 7W
Interface: USB Type C
Supported Operating Systems: For Windows, for Linux, for OS X (Currently only 64 bit software is available)
External Reference Input: SMA Female; 10MHz
External Reference Output: SMA Female; 10MHz or 100MHz
Signal Generator: Not accurately calibrated
Features:
1FREQUENCY RANGE: Provide an ultra wide frequency range of 100kHz to 6GHz, with 6 layer PCB design, optimized S12 port isolation and high frequency port matching. In actual testing up to 9GHz, both S11 and S22 have port directionality exceeding 10dB, while S12 S21 has dynamic performance exceeding 40dB. 2COMPLETE FUNCTION: USB based full 2 port vector network analyzer, three ADCs simultaneously sample data and use FPGA for signal processing, scan more than 10000 points in less than 1 second for full dual port measurement, suitable for DIY radio. 3FULL S PARAMETER: Can measure complete S11, S21, S12, and S21 parameters, generate source signals and alternately apply them to RF ports, measure input signals from two RF ports, and obtain four S parameters S11 and S21, as well as S12 and S22. 4SPECTRUM ANALYSIS: The general hardware architecture of the spectrum analysis device is sufficiently similar to that of the analyzer, which can achieve basic dual channel spectrum measurement and perform basic spectrum measurement to output CW signals. 5FIRMWARE UPDATE: With ultra low noise power design and the use of 16 bit for ADC, CNC aluminum shielding shell, which can achieve effective dynamic performance up to 100dB, supports firmware updates, and can load new microcontroller firmware and FPGA configuration onto the analyzer (do not disconnect the power).
Package List:
1 x Analyzer
1 x USB Type C Data Cable
1 x USB to 3.5mm Power Cord
2 x SMA SS405 Test Cable 30cm
1 x SMA Male Calibration Part OPEN
1 x SMA Male Calibration Part SHORT
2 x SMA Male Calibration Part LOAD
2 x SMA Male to Male Connector
2 x SMA Female to Female Connector
1 x 10dB Adapter
1 x User Manual
4 x Foot Pads
