Specification:
Item Type: Wideband Directive Antenna
Material: PCB
Mode: R101C
Basic Parameters and Their Explanations:
Frequency Range: 730MHz-6.5GHz
The R101C antenna has good transmission and reception performance throughout the entire frequency range. The standing wave rate is less than 2.0 and has good gain. When the frequency range is exceeded, the gain and return loss of the antenna will rapidly decrease, and the usage requirements will also be correspondingly reduced. When the standing wave ratio is less than 2.5, it can be used up to 700Mz to 7GHz.
Polarization Method: Linear polarization
The R101C antenna is a linearly polarized antenna. The polarization direction is vertical, which is the same as a vertical monopole antenna.
Gain Rated: 7dBi
The gain of R101C antenna slowly increases with the increase of frequency. At approximately 800Mhz, it is approximately 5dBi, at 2.4GHz it is approximately 7dBi, and at 5.8GHz it is approximately 9dBi.
Return Loss: 10dB
The input impedance of the R101C antenna is 50 ohms. When the 50 ohm impedance is connected to the signal source, the fluctuation within the frequency range is less than 10dB, and the corresponding standing wave ratio is about 2.0
Power Capacity: 5W
When using R101C antenna as the transmitting antenna, we recommend that the RF input power does not exceed 5W. Short term use can exceed 50W without causing damage to the antenna.
Directional Sensitivity:
R101C has good directional performance and small side lobes throughout the entire segment. It can be used as a direction finding antenna. The horizontal direction of the antenna pattern is relatively wide, with a -3dB width of approximately 60 ; In the angle of altitude direction, the directional pattern is very narrow, with a -3dB width of approximately 40 .
Mechanical Parameters:
Interface Type: SMA external thread, internal needle
Polarization Mode: Linear polarization
Input Impedance: 50
Working Conditions:
Temperature Range: -45to 80
Humidity Range: 0% to 95%, allowing short term 100 percent, without splashing
Waterproof Performance: Dry after spraying, replace the connecting wire after soaking
Wind Resistance Performance: For safety reasons, it is prohibited to use when the wind speed is greater than 20m/s (wind force level 8)
Features:
1MAIN FUNCTION: Printing gradient slot antenna. Suitable for directional wireless signal transmission and reception, signal source reconnaissance and direction finding, broadband signal testing, etc. Mainly used in laboratory environments. After connecting the handle, it can also be used for mobile direction finding. Stable performance and high product consistency are essential experimental tools for radio frequency workers. 2EXCELLENT PERFORMANCE: The antenna covers the common frequencies of radio frequency units such as mobile communication, UWB positioning modules, and WiFi. The antenna has good directionality, high gain, and small size. 3EASY TO INSTALL: The multifunctional bracket that supports the antenna can easily fix the antenna on the desktop or use it for handheld mobile use. 4DUAL USE: The rear end of the antenna is equipped with mounting holes. In addition to independent use, the antenna can also be fixed at the focal point of the parabolic reflector as a feed source for the parabolic antenna. 5DIRECTIONAL SENSITIVITY: R101C has good directional performance and small side lobes throughout the entire segment. It can be used as a direction finding antenna. The horizontal direction of the antenna pattern is relatively wide, with a 3dB width of approximately 60 ; In the angle of altitude direction, the directional pattern is very narrow, with a 3dB width of approximately 40. 6RETURN LOSS 10dB: The input impedance of the R101C antenna is 50 ohms. When the 50 ohm impedance is connected to the signal source, the fluctuation within the frequency range is less than 10dB, and the corresponding standing wave ratio is about 2.0.
Package List:
1 x Antenna
