Specification:
Item Type: Flameless Heat Induction Tool
Material: Flame Retardant ABS, Brass
Model: FH 1000
Equipment Protection Temperature: 80
Working Frequency: 50-60Hz
Rated Power: 1200W
Heating Temperature: 800
Heating 800Time Required: 5-40 Seconds ( The larger the object, the longer the time required )
Heating Bolt Diameter: The coil can be set to be, the coil can be freely adjusted.
Ambient Temperature: -40 -60
Relative Humidity: <95% RH
Atmospheric Pressure: 86KPa-100KPa
Function:
- There is a soft start function, with a long service life in the case of frequent starting.
- With IGBT over current protection function.
- There are input and output overcurrent protection automatic adjustment negative feedback function.
- With IGBT over temperature protection function.
- With heating coil short circuit protection function.
- With heating coil open circuit protection function.
- Full bridge series resonant circuit topology, strong anti interference ability.
- Using high performance IGBT driver chip drive, accurate drive and output waveform.
- Automatic load recognition and phase locking function, so that the load side to get a high power factor, but also to make the circuit control in the weak inductive area of high efficiency.
- Several electromagnetic heating controllers are installed in parallel on the same heating tube, without interfering with each other.
- Good Power Saving Effect: Compared with the current use of electric heating rings, power savings of up to 30% or more.
- Easy To Install: Can be connected to the barrel type and flat disk type and other structural methods of induction coils.
Features:
1High Efficiency: This electromagnetic induction heater utilizes an electromagnetic field to heat metal faster, more accurately, and more efficiently than an oxyacetylene system. 2Built In LED Light: This flameless heat induction tool has a built in LED light at the end, which provides illumination of the work area even when working in the dark, allowing for a clearer understanding of the progress of the work and the status of the object being heated. 33 Coils: This flameless heat tool is equipped with 3 different sizes of coils, 3 pieces of coils include 1 piece diameter 0.79in (20mm), 1 piece diameter 0.98in (25mm), 1 piece diameter 1.18in (30mm), a variety of coil models and sizes can be adapted to the work requirements in a variety of ways to make your workflow smoother. 43.0mm Brass Core: This magnetic induction heater consists of brass wire with 3.0mm brass core, which is more reliable than the 2.5mm brass core coils on the market, and can be heated up to 800 high temperature for a long time without fear of high temperature test. 5Wide Application: This magnetic induction heater tool is widely used for heat treatment of automobiles, machinery, and various small metal parts such as gears, pulleys, bearings and so on.
Package List:
1 x Induction Heater
3 x Heating Coils
2 x Screws
1 x Manual
