Product information:
Packing method: sealed bag
Working voltage: DC12V
Working current: 10mA@12V
Radiation power: 10mw@12V
Transmitting frequency: 315MHZ
Transmission distance: 120-150M (open and open, the sensitivity of the receiving device is negative 100dbm)
Encoder type: fixed code. learning code. rolling code
Function: copy remote control/test remote control/copy remote control
Size: 5.83.01.3cm
Weight: 35 grams
material: metal
Application range: The remote control is widely used, mainly used for remote control of some cars. Remote control electric retractable doors, elevators, remote barriers, remote control rolling doors, garage doors, sliding doors, remote control LED lights, remote control fireworks igniters, remote control passenger car doors , Anti-theft alarm, electric door alarm, MP3 motorcycle anti-theft alarm, etc.
Features:
Instructions:
1, Before copying, clear the test code copied in the factory production. The method is to press and hold the two buttons on the front of the remote control at the same time (usually the A button and the B button). Press the B key, then press the B key three times, short press the LED light does not light up, long press the LED light flashes three times to indicate that the internal code has been cleared.
2, Press and hold the key of the handset to not let go, hold down the key corresponding to the guest's handset and close to the receiving antenna, you can also adjust the angle of the two remote controls to achieve a good copy effect, about three After 2 seconds, the machines LED light flashes three times and then quickly flashes and then you can let go, try to press this button again, the LED light will light up, indicating that the learning copy is successful. The same operation is done to copy other keys.
3. Fixed frequency: 315MHz and customer demand frequency.
Adjustable frequency, the frequency of this machine is generally adjusted around 315MHZ when it leaves the factory. If the guest's remote control is at this frequency, it can be tried directly after the copy is completed. If the guest's remote control is not at this frequency, please adjust it to After the receiver responds, zoom out and fine tune until the farthest. If there is a remote control copy machine, the frequency measurement function can be used for accurate debugging. If the remote control is decorated with hardware, please lower 2-3MHz, and finally the case shall prevail.
4. Recovery function: If you accidentally reset to zero by mistake, press the two buttons at the same time, the LED light flashes to indicate that the internal code has been recovered
Packing list:
Remote control*1
