1The driver does not heat when electromagnetic parts such as electromagnet, solenoid valve energized for a long time 2It can control the strength of the thrust and the locking of the electromagnet. By adjusting the "PWM pulse width" potentiometer on the board, the force of the electromagnet on the board can be controlled. By adjusting the "FRQ frequency" potentiometer t 3Easy to control, the power supply is 7-30V. 12V or 24V power can be input to control 12V or 24V nominal electromagnetic devices 4Power-on moment, If there is a control signal, the drive plate will start the electromagnet with the maximum thrust, when the electromagnetism works stable, the electromagnet enters the locking working state, and the locking force is controlled by the po 5OTP over temperature protection and OCP over current protection are used to prevent load short-circuit protection, you can set the potentiometer to adjust the over current protection point