Specification:
Item Type: PWM Control Relay Switch
Material: Plastic and PCB
Type: RC Accessories
Input Voltage: 5V (connected to receiver)
Wiring Terminal: 30V DC , allowable current 2A 125V AC , allowable current 0.5A Relay coil power consumption approx. 140mW
Main Board Size: Approx. 29 x 9 x 8mm / 1.14 x 0.35 x 0.31in
White Relay Size: Approx. 10 x 6.5 x 5.4mm / 0.39 x 0.26 x 0.21in
Overall Length: Approx. 130mm / 5.12in
Suitable for RC cars, boats, tanks and aircraft models
Features:
1Adaptable to Higher Voltages: Unlike FETs, the PWM control relay switch is directly physically wired and can therefore be adapted to higher DC voltages and can also be connected to AC supplies. 2Normally Open and Common Terminal: The PWM control relay is connected above (>1750us) the normally open and common terminals (while the normally closed and common terminals are disconnected), then <1750us, the normally closed and common terminals are connected. 33 Second Delay: The PWM inside the control relay switch means the rudder signal, and if you can control the rudder, you can use this device. If there is a solder joint, it can be set to delay for 3 seconds and disconnect automatically. 4Automatic Disconnect: When the PWM control relay is soldering two solder joints, the automatic disconnect mode is switched on, the channel value is operated to a high level and the normally open and common conduction is automatically disconnected for 3 seconds, or it can be operated in advance to disconnect it for less than 3 seconds. 5Highly Sensitive: The PWM control relay can be set in a wide range of scenes, can control LED lights and has very sensitive light control, is small and lightweight and does not add extra weight to the RC car.
Package List:
1 x PWM Control Relay Switch
