Specification:
Item Type: Depth Gauge
Material: Stainless Steel 316L + Anti-Fog Glass
Installation Diameter: Approx. 52mm/2in
Depth Indication Range: Approx. 100m/110yd
Backlight Color: White
Working Voltage: 12VDC
Working Current: 60mA
Working Temperature: -30 to +75
Storage Temperature: -40 to +85
Protection Grade: IP67, the back cover is IP5
Operation:
A. This device is work with 12V system only, to indicate the depth appointed. Normally, the buzzer beeps once when it was connected correctly then turn on the power.
B. Keypad "Mode": Quick press the keypad "Mode" to switch SH/DP/KL/ UN Hold the keypad "Mode" to turn on/off the monitor. Short press the keypad ""to set the value required. Hold the keypad "to keep the digital increasing/decreasing fluently.
Parameter: SH: (Low level alarm) Range : 0-0.6-19.9, when the level no more than value(SH) appointed,the symbol flickering and the buzzer beeps all the time. If SH=0, no alarm alarm setting range is 0.6-19.9
Range:
- Unit M: 0-99
- Unit FT": 0-199
-
Unit F: 0-49 If the level exceed the a pointed value , the buzzer will beeps twice Keel offset (KL):
Range:
-
UnitM: 0-6.0
- UnitFT": 0-19.9
-
UnitF: 0-3.3
Installation Notes:
-
Make a 52mm/2in diameter hole on the panel of your cabin panel and instrument panel, insert the instrument into the hole. The panel corresponding to the instrument panel is marked with a boss, and make a small notch at this position to ensure that there is at least 52mm/2in of the instrument panel on the back of the instrument.
- After installing the instrument into the panel, screw it down with the fixing ring.
- Connect the wires and connect the instrument case directly to the 12 power supply.
- Insert the wire harness and fix it firmly on the table.
Wiring Instructions:
Red wire to the positive
Orange wire to the backlight
Blue wire to the negative
Features:
1Made of stainless steel 316L bezel and antifog glass, have excellent antifog performance and waterproof performance. 2The waterproof rating of the dial is IP67, and the back cover is IP5, can be used for a long time even in the cold sea environment. 3The maximum depth indicator is about 100m/110yd, allowing you to know the depth of the bottom in real time. 4Easy to install, good durability and antivibration, equipped with alarm performance, flexible and simple operation. 5Suitable for yachts, small and mediumsized boats, fishing boats and other marine vehicles to better meet your needs.
Package List:
1 x Depth Gauge
1 x Sensor (with Wire)
2 x Fixing Screw
1 x Bundle of Power Cord
1 x Instruction Manual
