Specification:
Item Type: Spot Welder
Material: Metal
Color: Red+Blue+Black
Input Line Length: Approx.20cm / 7.87in
Welding Pen Length: Approx.30cm / 11.81in
Weight: Approx.210g/7.4oz
Battery: lithium battery(Not Included)
Quantity: 1 Set
Instructions for use:
1: Power connection
The controller comes with a 20cm long 10AWG input wire. One end has been crimped with a U-shaped terminal, and the other end has not been processed. Connect the crimped U-shaped terminal to the control power input terminal, and the other end is processed according to its own power supply. Do not connect the negative electrode wrong.
2: Switch on and off
There is a power switch under the control board. After pressing, wait for 3 seconds. After the buzzer drops, the LCD lights up and the boot is complete. Press the power switch again to shut down.
3: Screen description and parameter adjustment.
4: Welding
Keep the welding pin clean. If the welding pin is polished into a round head, the welding effect can be improved. There are manual and automatic methods.
Battery Selection:
1: 12V car battery from 25 to 40ah, requires good performance and low internal resistance.
2: 4000 to 6000mAh 45C to 60C 3S model aircraft lithium battery.
3: 30 to 35ah 12V capacity lithium battery pack.
Welding Materials:
Welding 0.1~0.12mm thick nickel-plated steel strip
Energy Setting:
Energy must gradually increase from 01, and the maximum cannot exceed 50.
Exceeding the above conditions may damage the controller.
Features:
1The controller is controlled by a single chip microcomputer, and the output pulse is accurate to ensure the welding quality. 2Using automatic touch welding mode, while retaining the manual trigger interface, you can choose according to your own use. 3Wide selection of welding power supply: lithium battery power supply or 12V car battery. 4With LCD display screen, can display welding parameters. The controller is mainly for welding nickelplated steel strips from 0.1mm to 0.15mm. 5The welding pen and the input line are connected by Ushaped coldpressed terminals, which is convenient for disassembly and replacement. 6The power board uses 2 Gusi copper to increase the overcurrent capacity. Using 5 300A MOS tubes, nondisassembled MOS tubes. 7The MOS tube driver adopts the imported special chip driver. The fastest MOS tube can be hit with 20nS. The switch is fast to prevent the explosion of the tube and the non-triode push-pull drive. 8The MOS drive design adds a transient diode to protect the MOS and prevent the explosion of the tube. 910AWG multifilament flexible wire is used for the welding pen line and the input line to increase the overcurrent capacity. 10A 25V10000uF high-frequency low-resistance capacitor is added to the power input for energy compensation, which increases welding stability.
Package List:
1 x Controller
1 Pair of Welding Pen
1 Pair of Power Input Line(Red and Blue)
1 x Power Access Plug
