For example, 0-25mm.
- Equipped with calibration standard parts, spanner, and ratchet handle, which can accurately apply force.
5 Locking nut, powder-coated paint surface
-
Installed in a plastic box, hard alloy tip
Instructions for use:
-
Before use, clean the measuring surface and correct the zero position. 0-25mm is directly aligned to the zero position: the quasi-zero position is equal to or greater than 25mm.
-
The method of correcting the zero position: If the 0-position line is not aligned with the reference line, please use a screwdriver to loosen the screw, and then use a wrench to adjust the position of the reference line, and then align the reference line with 25-. Bit line, and then tighten it with a screwdriver.
- During the measurement, the micrometer should be perpendicular to the workpiece to be measured, and the force measuring device should rotate. When the measuring surface touches the workpiece, the force measuring device should be rotated slightly. The actual size of the workpiece to be measured.
- The locking device can passively measure the forward and backward movement of the micro screw. Release to the right and lock to the left.
- When measuring, you should hold the heat shield of your left hand to prevent the body temperature from being transmitted to the micrometer and causing measurement errors.
-
One end of the wrench can be adjusted to the zero position, and the other end can be used to tighten the force measuring device.
note:
-
Manually measure the size, there may be an error of 0 to 2mm, which is a normal phenomenon.
- And due to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!
Product parameters:
Color: Army Green
Type: 0-25mm
Material: stainless steel
packing list:
1 x micrometer
