Dial Hole Diameter: accurate measurement of the Inner Diameter Scale (18-35mm)
$ 100.99
Product description
Size: 18-35mm
Pre-use verification:
- Check the interaction and stability of the meter head.
-
Check that the active probe and the interchangeable probe surface are clean and that the connection is stable.
Reading Method:
Measuring the opening, the smallest dimension of the hole axis is its diameter, measuring the dimension between the planes, in any direction
The smallest size is the measurement size between the planes.
The measurement reading of the dial indicator plus the zero size is the measurement data.
Instructions:
-
Insert the dial hole gauge into the shaft of the straight manometer tube and compress the dial hole gauge one turn and tighten it.
- Select and install the interchangeable probe and tighten it.
- Hold the insulation when measuring.
- Adjust the zero position according to the measured size.
Adjust the zero position with a ring gauge of known size or a parallel plane (micrometer) to the minimum hole axis dimension
Or the smallest size in any direction between the planes is 0 bits, and then repeatedly measure the same position 2 or 3 times to verify if the pointer is still aligned with line 0, if not, adjust again.
For convenience of reading, the zero position can be determined by an integer.
- While measuring, rock the dial diameter indicator and find the smallest dimension (inflection point) of the axial plane to read.
- The measuring bar, the probe, the dial indicator, etc. They should be used together and should not be mixed with other tables.
width (mm) :80.00
height (mm) :80.00
Division Value (mm / inch):0.01
Weight (kg):0.600
Length (mm) :200.00
Measuring Depth (mm):70
Measuring range (mm / inch):10-18
width (mm) :190.00
height (mm) :120.00
Division Value (mm / inch):0.01
Weight (kg):0.900