Specification:
Item Type: Air Sander
Material: Stainless steel
Model: AT-1500
No-Load Speed: 15000 (rpm)
Air Inlet Size: 1/4 (inch)
Compressed Air Flow: 12CFM
Exhaust Direction: Rear exhaust
Air Connection Screw: 1/4-19NPT
Noise Value: Less than 83DB
Suggested Air Tube Inner Diameter: Approx. 6.3mm / 0.2in
Category: Oscillating Pneumatic Eccentric Grinding Machine
Refueling Tips for Eccentric Pneumatic Grinder:
- This machine is highly accurate. When it is running, the Speed is high. Once any fine sand or iron filings enter the movement, it may cause the blade to break and cause the machine to malfunction, so make sure that the air inlet is clean.
- Be sure to use an oil-water separator and drain regularly to ensure that the machine is dry.
-
Before use every day, be sure to add 3~5 drops of pneumatic oil to the air inlet of the machine, and connect the air pump to idle.
Need to Know for Changing Disc of Eccentric Pneumatic Grinder:
-
Locate the keyhole.
- Insert the positioning pin into the lock hole and keep the pin still.
- Turn right and replace the sand pad.
Size: Approx. 2.5cm / 1in
- 1cm / 2in
- 6cm / 3in
Features:
1Dedicated to all kinds of light and small metal dead corners, spray polishing, burrs, rust removal and detail trimming. 2Eccentric pneumatic grinder with 3MM yaw, strong force, can throw rough grinding work. 3Can change the air flow to control the speed of grinding, polishing and waxing. 4There are 3 sizes x 6 kinds of automatic polishing pads to meet your different needs. 5Complete tools, you can operate it yourself, suitable for DIY enthusiasts.
Package List:
1 x Sander
3 x 1 Inch/2 Inch/3 Inch Polishing Disc
9 x 1 Inch / 2 Inch / 3 Inch Flat Sponge Pad
9 x 1 Inch / 2 Inch / 3 Inch Wave Sponge Pad
3 x 1 Inch / 2 Inch / 3 Inch Microfiber Mat
6 x 1 Inch / 2 Inch / 3 Inch Artificial Wool Pad
15 x 1 Inch/2 Inch/3 Inch Sandpaper
1 x Positioning Lock
1 x 1/4 Air Inlet Connector