when the Temperature Probe is Installed, the Manual Speed is Used As the Initial Low Speed (bottom Line Speed). when the Temperature Exceeds the Accelerating Temperature, the Fan Speed Accelerates Smoothly with the Increase of Temperature. when the Temperature Reaches and Exceeds the Sum of the Acceleration Temperature and the Acceleration Width (full Speed Temperature), the Fan Runs at Full Speed.
Normal Operation: Click the Button Bottom Line Output Increased by 5%. Double Click the Bottom Line to Reduce Output by 5%. After Changing the Value, Run for 20 Seconds. Automatically Save the Parameters Until the Intermediate Indicator Stops Flashing. Enter the Temperature Control Setting by Long Press Button.
Temperature Setting State:
Speed Setting (slow Flash), Click and Doubleclick to Set Up the Value, and then Enter the Acceleration Width Setting by Long Press.
Acceleration Width Setting (flash), Click and Doubleclick to Change the Value, then Long Press to Save and Exit the Temperature Settings.
Note: If You Do Not Operate in the Set State for 20 Seconds, then Automatically Exit the Settings, Do Not Save Parameters.
Example Instruction:
Bottom Line 20%, Acceleration Temperature 35, Acceleration Width 15.
When the Probe Temperature is Lower Than 35 Degrees Centigrade, the Output Signal is Always 20%. when the Probe Temperature is Higher Than 35 Degrees, the Controller Can Increase the Output Signal Smoothly According to the Temperature Rise, and the Fan Accelerates. when the Probe Temperature Reaches or Exceeds 50 (35+15), the Controller Outputs the Full Speed Signal and the Fan Runs at Full Speed. According to the Specific Performance of the Fan, the Actual Speed of the Fan Will Be Somewhat Different.
The Controller Has Supported the Control of the Reverse Timing Fan. Specific Setting Method:
First, Power off and Remove the Fan. Press the Set Button to Electrify the Controller. Keep the
Settings Button Always Hold (about 3 Seconds) Until the Three Lights Turn into Double Flash State and then Release the Button.
The Indicator Lamp Turns into a Single Light, Which Represents the Entry Mode Setting State.
The Controller is Divided into Three Kinds of Working Modes, Corresponding to 1, 2, 3
Indicator Light Double Flashing, Through Short Press Button Switch, Set the Long, Press the Button to Save and Exit the Set Mode and Automatically Back to Normal Working State. the Three Working Modes Are As Follows:
