Specification:
Item Type: SDR Transceiver
Material: Aluminium Alloy
Battery: 1 x 3500mAh lithium battery 605585, delivery with built in battery.
Function:
Radio Transceiver: A QRP SSB HF transceiver with embedded DSP and SDR functions.
Launch: EER E level driven SSB launch stage.
Output: 13.8V power supply provides about 10W PEP SSB output.
Full Mode Support: USB, LSB, CW, AM, FM
DSP Filter: 4000, 2500, 1700, 500, 200, 100, 50Hz passband.
DSP Function: Automatic gain control (AGC), noise reduction (NR), voice trigger, voice trigger Xmit (VOX), RX attenuator attenuator (ATT), TX noise gate, TX driver control, volume control, dBm S meter
SSB Reverse Sideband and Carrier Suppression Transmission: Better than -45dBc
Two Tones IMD3: -33dBc, reception: better than -50dBc.
Multi Band Support: Continuously adjustable in the 160m-10m frequency band, and performance loss from 20kHz to 99MHz.
Open Source Firmware, Built in for IDE: Allows experimentation, can add new functions, can share contributions through Github, software complexity: 2000 lines of code.
Features: Software based VOX can be used as a fast full invasive (QSK and semi QSK operation), or to assist in running in digital mode (without CAT or PTT interface) for RX/TX switching, external PTT output with TX/PA control delay
Installation: Simple installation modification with 8 component changes and 8 wires.
High Efficiency: Thanks to EER transmitter E level, it has high power efficiency (no bulky heat sink required), and simple design (no need for complex balanced linear power amplifiers).
SSB Transmitter Stage Based Entirely on Digital and Software: By controlling the phase of the SI5351 PLL (via the tiny frequency change of I2C over 800kbit/s) and the amplitude of the PA (via the PWM of PWM) to sample the microphone input and reconstruct the SSB signal. PA key shaping circuit).
3 Independent Switchable Analog Front End Receiver Attenuators: 0dB, -13dB, -20dB, -33dB, -53dB, -60dB, -73dB
Receiver Noise Level MDS: -135 dBm (200Hz BW) at 28MHz.
Receiver Front End Selectivity: Steep tuning frequency -45dB, ten times roll off +/- 2kHz
Blocking Dynamic Range: 20kHz offset 123dB, 2kHz offset 78dB.
CW Decoder: Straight, Iambic-A, B keyer, VFO A/B + RIT and Split, and switch the corresponding relay band filter through I2C
Supporting CAT with TS480 Subset: You can stream audio, press keys, and display text through CAT.
SDR SSB transceiver: Great simplification simplifies the original QCX circuit, that is, reducing the installation components by 50%, does not require complex transformer windings, and does not require alignment procedures.
Port Introduction:
Charge: Charging port of the built in lithium battery and can only use the supplied charger. It is forbidden to use other chargers
Switch: OFF to shut down.
BAT: Built in battery power supply.
13. 8: External power supply
DC 13.8V 3A: External power supply port
KEY: Automatic key body connection, A, B, single key.
PA: External power amplifier, PTT signal.
MIC: External microphone port.
UART: Serial communication port, command compatible with TS-480.
SPK: External speaker.
Features:
1Reliable Work: A pocket sized 8 band SSB CW QRP transceiver designed with built in lithium battery, built in microphone, PTT button and extremely low RX current consumption, it is a good partner for SOTA, POTA or any other portable activities. 2Better Design: This QRP SSB CW shortwave transceiver has a large screen, built in battery, charger, built in microphone and speaker. It can be connected to an automatic button. It can also be decode CW coding. 3IRF Launch Tube: With durable IRF series launch tube, can be used to connect antenna, which is on the instrument base. 4Simple Structure: All aluminum buttons and translucent silicone buttons, the original transformer qcx circuit is greatly simplified, and the installation components are reduced by 50%. No complicated windings. There is no wiring procedure. 5High Efficiency: High power efficiency and simple design, thanks to eer electronic level transmitters, also very convenient to carry.
Package List:
1 x SDR Transceiver
1 x Mic
1 x Charger
1 x 3 in 1 Screwdriver
