Product information:
Main features:
Small size, complete functions, simple operation and convenient carrying. It can be powered by an adapter or a lithium battery. Together with oscilloscope, it can be used for electronic circuit test and debugging, frequency characteristic and pulse response test and measurement of audio amplifier. Due to the good accuracy and frequency stability of DDS, it is also very suitable for oscilloscope scanning time factor calibration. Square wave output is suitable for oscilloscope attenuator and probe pulse characteristic adjustment.
Main technical indicators:
- Frequency range: sine wave 1Hz-500kHz (where the frequency with flat output amplitude reaches 200kHz, and the output amplitude will decrease with the further increase of frequency), other waveforms 1Hz-20kHz (but the upper limit of adjustable frequency is not limited, and the use frequency can be further increased if the requirements for distortion and shaking are not high).
- Resolution: 1Hz.
- Output waveform: sine wave, square wave, triangle wave, forward sawtooth wave, reverse sawtooth wave.
- Sine wave distortion:<1% below 1kHz,<0.5% above 1kHz.
- Output amplitude: maximum10V (P-P)
- Output impedance: 50 .
- DC offset: maximum10V, relevant closing function.
- There are filters that can be turned on and off, which can be well adapted to sinusoidal and pulse waveform output.
- Power supply: DC3.5-10V. It is recommended to select DC5V when using adapter, and 3.7V lithium battery when using battery power supply.
- Boundary dimension: 125x80x32mm
Packing list:
Signal generator+data cable+instructions * 1 set




