After drying, this product is a hard, inelastic solid, super high temperature resistance, electrical insulation, not waterproof at the beginning, but mildly resistant to water and oil after high temperature porcelainization. According to the characteristics of the product, you can study it for other uses. Currently there are buyers Repair ovens, fireplaces, electric stoves, heating rods, laboratory reactors, etc., and the response is good ... (other uses outside the exhaust pipe, please study by yourself)
Because of the brittle and hard features, such as the exhaust pipe is loose, loose, leaking water can not be used. Damage is larger than nails and it is more difficult to repair. We can't test one by one for other uses than the exhaust pipe, please research it yourself.
General usage:
[1] New equipment: Apply this product to the inside and outside of the exhaust pipe, exhaust pipe interface (about 0.65 mm thickness), then install it in the normal position and dry it to seal it. If you want to make it easier to disassemble in the future, you can only temporarily plug the exterior.
[2] Repair: first clean the surface, remove dirt, grease, rust with a descaling brush (available in our shop) or sandpaper, and then evenly wipe it in small holes and cracks to dry it.
[3] If the damage is less than about 3 mm, you can directly repair it. If you repair a slightly larger hole, you need to add a fiberglass net as a skeleton (the shop sells a 5 * 12 cm piece). The glass fiber net is one centimeter larger than the damage. Above, apply glue to the damaged area, cover the net, and then cover with glue. After applying, dry naturally for 12-48 hours. Observe the actual hardening before restarting. If it is difficult to dry due to cold and wet weather, you can also use warm warm air to accelerate drying.


